Search models, users, collections, and posts
Print Profile(1)
0.13mm layer, 2 walls, 100% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
4
15
1
0
61
38
Released
Description
Content has been automatically translated.
As with the original
This model is a replacement for a Corsair Strafe keyboard foot but with the original 10° inclination
The model must be printed precisely, otherwise the foot pin will not fit into the keyboard and the retention effect will not be there
I printed with a 0.4 nozzle at 0.13mm layer height
100% infill. The piece is a tight fit, 0.5mm wider than the original, but it works very well once inserted
I strongly recommend replacing both sides at once
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)