Search models, users, collections, and posts
Corsair K55 2 Replacement Legs / Feet
IP Report
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
7
5
6
2
52
40
Released
Description
This is a modified version of this model: https://www.thingiverse.com/thing:5415143
Feel free to boost me! As of 29.09.2026 I'm planning to make the model a little better, with a couple different sizes to choose between.
In the original one, it was pretty difficult to get the feet out, but i made it easier with my minor upgrade.
It is also slightly longer, and a tiny bit wider, but its not very noticeable.
The feet shown in the images were printed with ST-PLA on my Bambu Lab A1 Mini with the “Generic PLA” profile. I recommend printing them in black if you have the possibility.
Only takes about 2g of filament, roughly 8 minutes to print (excluding the pre-print calibrations. No supports are needed.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (6)