Search models, users, collections, and posts
Winch Drink holder
IP Report
Print Profile(2)
77/85mm 0.2mm layer, 99 walls, 99% infill
Designer
4.8 h
1 plate
Mesh bottom - 0.2mm layer, 2 walls, 15% infill
2.9 h
1 plate
Open in Bambu Studio
Boost
116
445
14
10
669
332
Released
Description
This drink holder is designed to fit into a standard winch handle fitting, providing a secure spot for your beverage while sailing.
The photos showcase a print made with PA6-CF. For best results, I recommend using a strong, temperature- and UV-resistant material such as ASA or Nylon, though other materials can be used as well.
Supports are recommended for printing.
The design consists of two stages and is intended to accommodate a stubby with a cooler.
- Small inner diameter: 77mm
- Large inner diameter: 85mm
Note: The photo of the holder on the yacht is of a earlier prototype with different dimensions. The Other photos show the make with the uploaded dimensions.
If you need alternative dimensions, feel free to leave a comment—I’m usually quick to provide updates!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (14)