Search models, users, collections, and posts
E.M.M.I Figure (Metroid)
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
7.5 h
1 plate
Open in Bambu Studio
Boost
170
300
29
12
266
96
Released
Bill of Materials
Bambu Filaments
Select all
Description
A figure of the EMMI from Metroid Dread.
There are 2 faceplate options, a large one for the white EMMI, and a small one for the colored EMMI.
Every model is oriented correctly and requires support enabled.
Do not try to flip the faceplate prints upside down, as it makes a bad-quality faceplate.
Print Settings
.2 mm Layer Height
10% infill
Supports enabled (I don't recommend organic supports for this print)
Coloring
I colored the model using a set of Sharpies, and it turned out well. You could also paint it for a good result.
Thingiverse Post: https://www.thingiverse.com/thing:6725120
Boost Me (for free)
If you like the model, please consider boosting! I will be a little more motivated to make an AMS compatible model if I get a few more boosts ;).
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (29)