PHILIPS LatteGo beam extension - Free 3D Print Model

Search models, users, collections, and posts

Skosiek

Household>Other House Models

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

4.7(97)

Open in Bambu Studio

Boost

307

890

112

1.5 k

935

Released

Description

PHILIPS LatteGo beam extension. Increase the capacity of coffe beams tank by 200g. May need brim, to prevent wraping, depending on printer

Comment & Rating (112)

@user_3342034796

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

(actually) quite brilliant I'm giving it a slightly lower rating due to the following issue: The frame fits perfectly, but sits a little loosely at the bottom (naturally, there's no seal) However, the lid with the seal sits relatively tightly on the frame There's a risk that when lifting the lid, you also lift the frame, which could cause a small problem 😅 Overall, really great, I would just prefer a version with slightly thicker upper walls so that the lid sits more loosely

Show original

@user_2385499018

I agree completely - I'm thinking of printing a gasket out of TPU to fit the bottom edge - it also would benefit from a slight lip so you can hold it down while removing the snugly fitting lid.

@user_2385499018

Replying to @user_2385499018 :

I did create a sealing lip out of TPU but it didn't really work very well. It would probably be better if this whole thing was printed in TPU and perhaps modified to be slightly more snug for a snug fit on the device itself. For anyone interested in making a "gasket" it wasn't too difficult to import the file into Fusion and then project the inner and outer permitter onto a plane and then draw lines between projected points and 3 point curves for the curved portions then extrude.

@user_2385499018

Replying to @user_2385499018 :

the work was a bit tedious and I'm happy to share my fusion file if anyone wants to play with it and see if they can get it to work.

(Edited)

@bosch_cb

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfectly fits like a glove

The profile uploader has replied

Show original

@skosiek

Glad it fits :)

@Tom_Wolfsburg

Hi, thank you very much for the STP file. I have slimmed down the top and bottom using an offset and widened the area around the powder compartment. 2x Tesa tape on the sides for safety but not really necessary; the lid now goes on very easily. Printed with transparent PETG from Giantarm (Geeetech)

Show original

@user_2047380141

could I get the changed step file

Show original

@Tom_Wolfsburg

Replying to @user_2047380141 :

Hello, that would be no problem if I knew how. The original version is for the Latte Go, I had adapted the version for the Phillips 5400 series. I had confused it before. I will try to upload the file.

Show original