ARRMA GORGON +10MM Suspension KIT

Arrma Gorgon +20mm Wide Suspension kit.

I wanted to put together an easy-to-use kit, an on A1 mini this takes 2 plates and about 9 hours total to print. But it includes everything needed to extend your Gorgon's wheelbase +20mm. 

I remixed @dirtyboots702's front arms to accommodate the front shock properly by enlarging and giving an angle to the shock tower hole, as it wouldn't fit in the original design. 

I also remixed the original rear upper control arm to add the needed +10mm to each side and included some ARRMA lettering on the rear lower control arms. 

I have printed in PETG and so far, have had no issues. 

See @RC_Perspective's notes on the +10mm kit I remixed the rear lower control arms from. These need some post processing work with an M4 and M3 drill bit.

Thank you