iPhone MagSafe filter holder 58 mm - lightweight

A MagSafe iPhone filter holder with 58 mm filter thread.

Designed to be used with the original Apple MagSafe Silicon case.

Practical solution if you want to use a ND-filter or a CPL-filter on your iPhone for filming and photography.

Putting on a clear or UV-filter could also help protect your iPhone’s lenses in rough conditions like salt water.

A lightweight solution which can be attached/detached quickly.

The following is needed for assembly:

• MagSafe compatible Magnetic base
  • I used this one: https://www.amazon.de/gp/product/B092CG8YW9/ 
  • Another one (Amazon US): https://www.amazon.com/dp/B094BBZS4Z 
  • Similar ones can also be found on platforms like Aliexpress
    • Make sure to not get the plastic ones, as they differ in thickness (the above listed are made from aluminium)
    • Look for one with the following dimensions: 5.5 cm in diameter, around 0.24 / 0.25 cm thick
    • Cut-out in model is designed for up to 5.65 cm and 0.27 cm
• Some glue

Compatibility

• Tested with
  • iPhone 16 Pro with original Apple Silicon Case
  • iPhone 15 with original Apple Silicon Case
  • iPhone 14 Pro with original Apple Silicon Case
• Not compatible with Pro Max iPhones
• Not tested with other MagSafe compatible iPhones
• Not tested with other cases than the original Apple MagSafe Silicon cases. The original Apple Clear Case should also work though.
• Magnetic base is not recommended to be used without case

Assembly

• Test out, if 58 mm thread works for you as intended. The thread was created according to M58 x 0.75 ISO specification used for most photographic filters.
• Test the fit of part 2 to part 1 and to part 3
• Glue part 2 (textured surface up) to part 1
• Glue part 3 (the magnetic base) to the rest