Search models, users, collections, and posts

Sticks for snacks-sushi-small hands

3D-WorkShop
Tools>Hand Tools
IP Report

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1
H2D
H2D Pro
H2S
P2S
H2C
X2D
A2L
0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
2 plates
4.9(184)
Open in Bambu Studio
Boost
1422
2760
210
77
3.2 k
2.3 k
Released 

Description

Sticks for snacks-sushi-small hands, good stuff.

Comment & Rating (210)

(0/1000)
@SwizzY
Hey there, love the design. Not sure if anyone else has the same issue but on both sides where it curves I'm getting stringing on each side. I've tried two different filaments and dried both, printed on P1S.
The designer has replied
0
Reply
@user_1291491145
You should add supports
0
Reply
@SwizzY
Thanks for the reply. Would be great if the print profiles included the supports.
1
Reply
@ssweat
Replying to @SwizzY :
try my original design these people are stealing it from https://makerworld.com/en/models/748000-gaming-finger-chopsticks-helping-hands?from=search#profileId-1096582
0
Reply
@sammniam2
Print Profile
0.2mm layer, 2 walls, 15% infill
friend found this on a Reel, asked me to print a few. very cute.
2
Reply
@ssweat
design concept stolen from me here https://makerworld.com/en/models/748000-gaming-finger-chopsticks-helping-hands?from=search#profileId-1096582
0
Reply
@Faboskystudio
hehehehe awesome thank you
Show original
1
Reply
@B_Rowlett
Print Profile
0.2mm layer, 2 walls, 15% infill
The print was great and the hands fit on the sticks perfectly. I put a drop of Krazy glue on each hand to secure it in place and they are good to go!!!
0
Reply
@EddyDerksen
Print Profile
0.2mm layer, 2 walls, 15% infill
You can grab with this
Show original
0
Reply
@user_3010637505
Very nice print!
0
Reply
@user_804591476
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice The print profile should have pre-defined supports
(Edited)
Show original
0
Reply
@xariton
Print Profile
0.2mm layer, 2 walls, 15% infill
Everything went just great!👍💪 Thank you!🤝
Show original
0
Reply
@Andi84
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice idea. Printed in PETG. Easy to use even for thick fingers
Show original
0
Reply
@mingging
Print Profile
0.2mm layer, 2 walls, 15% infill
haha
0
Reply

License

This user content is licensed under a
Creative Commons Public Domain

Related Models

Gaming Chopsticks V1 and V2
Gaming Chopsticks V1 and V2
Chris1974
32.7 k
7.9 k
Snacking sticks
Snacking sticks
KingPavli
2.7 k
756
Mini Bag Clip
Mini Bag Clip
fifindr
109.1 k
23.4 k
Sushi Keychain
Sushi Keychain
holyravioli
958
1.4 k