Ski and Snowboard Service Vise

I have 2 Workbenches where you can already clamp in something, but the Service Vises I found out there were to be mounted with additional clamps, so I decided to desing my own. I gave some extra space for the ski and snowboard cut-outs, because I had some left over rubber band to mount on each of the sides.

The cut out for the ski is 35mm and for the board 30mm.

I used strong 3M assembly tape to get the rubber band attached.

The 3mf model has some brim added, because I had some serious warping on the first try (maybe in the garage it was a bit too cold). With the brim it came out well.

Top, bottom and side walls I configured 6 layers and used 0.2mm “Strength” setting from Bamboo lab with gyroid infill @ 25%.

It appears to be really strong and won't break easily.