Search models, users, collections, and posts
Dell WD15 docking station mount (only 18 cm width)
Remixed by
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
13
53
11
5
146
109
Released
Description
This is a remix of https://www.printables.com/model/902101-dell-docking-station-wd15-mount-under-table.
I needed a smaller mount for the Dell WD15 docking station so I could print it on the Bambulab A1 Mini. I shortened the pieces for the screws while retaining a part of the bevels for strength. The curves at the screw ends were also flattened a bit. In this way it perfectly fits the plate of my Bambulab A1 mini printer (print with tree support).
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)