Diamond Painting Boat 12cm x 7cm - Magnet Insert

Update 21.08.2025 → New print profile added! DP Tray Version 1.1

• Added a card holder / note holder to the front, so you can quickly swap DMC codes without always sticking them For this, it's best to stick the DMC adhesive codes onto a piece of paper and then slide it in This way, it can be reused repeatedly
  The card holder can also be removed in the slicer if you don't want it
  Dimensions for the suitable notes: Width 30mm, Height 10mm+, Thickness 0.5mm
• If you don't want the card holder, simply delete the “Note Holder” and “2mm height color matching holder” positions
• The “2mm height color matching holder” position is a modifier that only serves to make the bottom 2mm of the card holder a different color For example, the base (2mm thick) is white and the bottom 2mm of the card holder will also be white Hope that's understandable :-)
• Additionally, the press-in depth of the symbols and fonts has been adjusted! (from 0.5mm to 0.2mm)

Diamond Painting Tray 12cm x 7cm in 2 Variants with Magnet Insert

Normal diamond painting trays were too boring for my wife, so I had to get to work and create something myself :)

You have 2 plates to choose from in the file, depending on how you want the text So, mirrored variants

Depending on which hand you paint with and whether you want the “Diamond” lettering at the front ;)

You can also print the tray in various colors The base, lines, and dish can be set with their own colors

Suitable magnets: 10mm x 2mm

The 3mf file has been adjusted by me to fit perfectly for printing However, I will list a few more facts

• The file was set with wall mode “Arachne”, the tray and the stoppers can also be printed without “Arachne”, but the lid should be printed with “Arachne” to achieve a good result!
• By default, the “0.4mm stopper” fits very well! However, I have included 0.3mm and 0.2mm stoppers in .step format I set the stopper with variable layer height to achieve a good finish
• Note on the stoppers: If you reduce the bridging speed (external) from 50mm/s to, for example, 30mm/s, the bridge will be even finer, but then you will need to use the 0.3mm stopper
• So just leave it as is and the 0.4mm stopper fits :)
• The magnet insert is designed so that the magnets fit even with shrinkage Since I, for example, have 10x2mm magnets at home but they are unfortunately 10.1mm x 2.1mm, I had to adjust tolerances Of course, more is always good, but for exact models, it's impractical
• Therefore, don't worry, the magnet insert is created with a tolerance of 10.4 x 2.35mm and the magnets just slide in :)
• I have set the speed to a maximum of 150mm/s to have a good balance of quality and speed

My 12cm x 7cm trays also fit wonderfully into my garage, which you can find on my page :)

I have also uploaded a revised Version 2 with a different design Feel free to check my profile or directly via the link: DP Tray Version 2

If you have any questions or anything else, just write to me or comment :)