Jigglypuff - Pokemon
Copyright Claim
Jigglypuff - Pokemon
Boost
119
274
45
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
50mm high - 0.2mm layer, 3 walls, 10% infill
55 min
1 plate
𝐀𝟏 𝐌𝐈𝐍𝐈 - 0.2mm layer, 2 walls, 15% infill
2.2 h
1 plate
PLA 0.16mm
2 h
1 plate
Open in Bambu Studio
Boost
119
274
45
5
559
355
Released
Description
50% scale model
0,2mm layer height
0,2mm Top Z distance
Smoothened Top surfaces
Comment & Rating (45)
All
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
cute print model for my little girl...thank you
1
Reply
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
perfect just wish it could be done with no supports using fins . fits in the v2 pokeball
0
Reply
Print Profile
50mm high - 0.2mm layer, 3 walls, 10% infill
很可愛的神奇寶貝。
0
Reply
Print Profile
PLA 0.16mm
Decent print. thank you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out really well. smooth but with a tiny bit of stringing. nice print though.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well but the profile puts supports under the feet and i feel they should not be needed (the feet should just be on the plate, i think it might be a problem of the model). They are both hard to remove completely or to leave on as they came off partially while removing the rest of the supports. The model is really cute!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Slight issues getting some of the supports off, but otherwise a really great output!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great only complaint will probably be the support on the bottom was really stuck to the print not as flush as I would like but it’s a great print
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Related Models
© 2024 MakerWorld