Search models, users, collections, and posts
Handle for LoboCNC's EZ Drill Chuck
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 20% infill
Designer
2.7 h
1 plate
0.6mm nozzle, 0.18mm layer, 2 walls, 20% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
43
93
7
2
92
47
Released
Description
Here I created a handle for the EZ Chuck from LoboCNC.
Basically I just attached a handle to the lower screw part of the chuck so it can be used as a hand tool for easily drilling out holes by hand.
For assembly of the chuck please refer to LoboCNC´s original post
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)