Angled Funnel - Free 3D Print Model

Search models, users, collections, and posts

The_Red_Die

Tools>Other Tools

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.4mm nozzle, 0.2mm layer, 2 walls, 15% infill

Designer

1.6 h

1 plate

4.9(67)

0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill

Designer

1.1 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

227

593

1.3 k

922

Released

Description

Funnel 100mm at an angle, i needed one for transmission oil change in NAG1 maybe you will find another use for it.

Outer diameter of pipe is 14.5mm

Make sure you have good cooling near end of printing.

Boost Me (for free)

One click for you (for free), one step closer to discount for me!

Comment & Rating (74)

@KailuaKid

Print Profile

0.4mm nozzle, 0.2mm layer, 2 walls, 15% infill

Other Issues:not sure why the inside printed with exposed strands. I did cut a few of the larger ones out, it still works as a funnel, just a bit odd on the inside. Also the very (bottom) from print perspective, as in the large side, half of it didn't bond the same for about 2-3cm.. That half moon ripped off while removing it from the bed.

The profile uploader has replied

@the_red_die

Looks like too much speed, this is PLA or PETG? I set outer wall speed to 100mm/s and always printed in PLA. Will check tommorow with PETG

@KailuaKid

Replying to @the_red_die :

I used PLA, it's one of only 2 or 3 times I've ever had this issue, no end of world scenario, it is still useable, just wanted to let others see in case it duplicates.