Helldivers Helmet/Skull (Display)

! The model shown in the picture was painted !

Helldivers Helmet display for your shelf / setup (12cm high).

Already print-ready. The parts need to be glued together, while the connector helps to find the right position for gluing.

The print plate model is a bit tricky to clean up and there will be a seam line down the middle, which you can fill with pollyfilla and coat it with a primer to make it less to none visible.

You can also try to slice the raw helmet by tilting it on the chin at an angle, to print the helmet as a whole piece, but the risk of the print failing will be higher.

If you find a better way to slice the helmet without a noticeable seam line, you can share it in the comments.