CYMA MP5 Handguard with standalone grip.

This is a handguard for MP5 CYMA model inspired by MP5K and Romanian grips. 

Huge thanks to @michalgerhat for creating a basic handguard that i used as my canva and to SJHCreate that created the foregrip. Check them out.

All i did was combine these two elements into one using blender software.

This way i created the handguard i wanted initially, thanks again!

Incredibly comfortable, possible to hold it in various positions.

NOTE: Pin holes might not perfectly align, i used soldering tool to widen this hole, you might not encounter this, but just letting know.

Used 0.25 resolution and 35% infill, 4 walls (not necessary, it just happened to be set up for me).

 Tree supports were most economic, use them.

 Print time around 8-9 hours. Print vertically, this way you will achieve best durability.

Good size battery fits inside, only slightly smaller than stock handguard.

Grip is hollow, i didn't edit this intentionally, thought that it could be used for something later on, electronics perhaps.

If needed, i can edit the model and post more files, just let me know.