Search models, users, collections, and posts
Full Size Glock Stand and 4 Mag Holder - 40 & 9mm
Remixed by
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
6.2 h
1 plate
45 ACP, 0.2mm layer, AF PCTG, 112% scaling
10.6 h
1 plate
Open in Bambu Studio
Boost
224
591
102
27
636
415
Released
Description
This is a remix of very nice stand posted by bd122le (https://makerworld.com/en/models/665645#profileId-593135).
I have adapted it to better fit a full size & long-slide pistol and an additional mag (4).
It will work for double-stack 9mm / .40 S&W / .357 Sig Glocks (i.e. not Slimlines). Tested with G19, G17, G34. It holds all well. I prefer this size for the full size and extended models.
Modifications include:
- Removed some height from the base - saving quite a bit of filament.
- Adjusted angle of the post/holder to be somewhat flatter for a full-size variant.
- Extended the entire model and added another magazine holder in the process.
- Adjusted infill settings to save on filament while strength still appears fine. You can easily make more solid if you wish.
- Changed settings for the top fill. I like the starburst effect.
- Added color-fill with AMS compatibility.
- Note: The bottom inset has just the bottom of it filled (it will switch between black/white on those layers). The fill for the logos by the magazines was added by the layer. This reduces the number of times the printer has to change colors and reduces waste with purging and priming.
The
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (102)