Print Profile(3)
Description
Table lamp
Required:
0.65m 12V LED strip e.g. RGBCCT with connection cables, controller and power supply
Some hot glue to fix the LED strip
2x M3 screw (approx 16mm)
2x M3 heat-set insert (approx 8mm)
(4x rubber feet or felt)
I used PLA for printing the top part; I printed the back in white and the diffuser in transparent
The base consists of glossy PLA Silk in silver
Tools:
Soldering iron possibly solder
Hot glue gun
----
I recently created the lamp again. The Bambu Cool Plate SuperTack offered even better adhesion and a smoother surface
First, install the electronics, remembering to thread the cable through the cover and test for function, then assemble everything. If the transparent cover doesn't fit into the inner circle immediately, simply remove one track of the spring from the inside of the (white) back. First insert the transparent front part a little further down/in the middle into the back and then push it up, then fully insert it into the slot at the bottom of the (white) back and finally press the (transparent) edge against the (white) back on the front, it should click into place all around there
Boost Me (for free)
If you like my model, feel free to leave a comment, maybe with a picture or a boost, if not, feel free to write to me, maybe I can help or adjust something small.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (12)