Side plate for NLR GT Lite Pro

I designed this plate, so I could mount my throttle (X52 Pro) to my racing chair. The design, as seen, is for the left side of the chair. You would have to mirror it to be used for the right side for the stick (the screw holes wouldn't line up otherwise), but since the NLR GT Lite Pro has one metal side plate by default, there shouldn't be need to have 2 of these. 

For people not using the .3mf, I used 100% infill with 6 wall loops for everything. I printed it resting on the shaft at an angle (see pic above), because I ran into issues with the shaft breaking when printed face down. You could probably get away without the support trees, but I didn't try that.

I does its job for me and I already walked/stubbed my knee against it more than enough and it didn't break yet. Perhaps depending on what filament you use, your mileage may vary. I just used a basic PLA from BambuLab.