Cara Delevingne HueForge 3 Colour
Print Profile(1)
Description
As with all Hueforges, the transmission distance (TD) of the filaments used is pretty crucial. I use filament from readily available manufacturers in the UK, so as much as possible, please stick to the filaments listed, or check the TD of any you substitute (especially the white - in this case, you're probably fine with a slightly higher TD white, but I wouldn't go any lower).
Before printing, make sure your plate is clean. I often have adhesion issues with larger prints (especially flatter ones like HueForges) - they are nearly all solved by cleaning the plate. I've also started using 3Dlac - it's not cheap, but a little goes a long way and I recommend it highly.
If you're going to resize this in the slicer, please don't touch the Z axis! This is vitally important! Only resize the X & Y axes, and realise that your results may vary from what is intended in my print profile.
Project: Cara Delevingne 1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 149.6x149.6mm in size
You may print at higher layer heights below the Min Depth of 0.72mm
The Max Depth is 2.2mm and the Actual Depth is 1.9mm
Filaments Used:
PLA Deeplee Black Transmission Distance: 0.8
PLA Deeplee Grey Transmission Distance: 4
PLA Deeplee White Transmission Distance: 5.6
This print uses 3 unique filaments
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Grey
At layer #16 (1.36mm) swap to White for the rest.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)