Heather's Stand
Print Profile(1)
Description
This is a stand to hold tracing boards for diamond art and drawing\tracers; among other things. The bed is large and will not fit on the A1 Mini. The kick stand and bed both use 3 (total of 6) 8mm by 2mm neodymium magnets (max 2.5mm [depending on print capabilities, on the larger ones you may need to make a gasket by cutting part of the kick stand and printing that as an additional to the original kick stand); these magnets need to be glued in and in the correct polarity. I choose to not use pressed in holes due to inconsistency between print quality and tolerances that would make the interference fitment unusable to some people. Supports and brims also a must. The lip at the base of the bed will give you 5.5mm of clearance to hold. The flats on the disk and bed could have neoprene foam or other material attached for a specific anti-slip.
Confirmed fitment for light boards:
https://www.amazon.com/dp/B0CBMRKZ8C?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
https://www.amazon.com/dp/B07TMKSYPM?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Magnet kit I used, any rare earth 8mm by 2mm should work just fine:
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)