Carpet Gripper for Fanatec CSL Elite V1

There was a similar file I found on thingiverse linked here. https://www.thingiverse.com/thing:3546990

I liked the idea, but I didn't want to use the the spacers. After looking at the file it didn't seem like it would print very well with the overhangs (to be honest I didn't try it though) and it seemed a bit too bulky, so I designed my own from scratch.

I preferred the holes just fit right over the 5/16 / 8mm all thread rod that fits the rear holes of the CSL Elite pedals. I assume this should work with the CSL Elite V2 pedals (assuming the hole spacing is the same as the V1). That said I have the V1 pedals. So I cannot say with 100% certainty that it will fit. If it does, someone please comment and let me know and I will update the description to reflect that.

The file is set to be 10mm wide. Use the scale tool (be sure that the uniform scale checkbox is UNCHECKED or it will ruin the hole scaling) to make it as tall as you need. I set mine to 30mm tall and that seemed like a good setting to me. 

I printed it on matte black bambu PLA. Seems plenty strong enough to me and seems to have good grip on the carpet. My carpet is thick and shaggy, so if your carpet is thinner/more dense this design may not be the best. Again I only have a sample size of my own carpet and it worked well for me with no back stop.