Hanging lamp Pendant light decorative ambient

Hi!

I designed this hanging lamp for in our hallway. Each lamp consists of 20 slats, 2 mounting plates, 1 E27 bulb and a cord with a lamp holder. It's recommended to use two locking rings on the lamp holder to clamp it on the mounting plates, one is included with the cord and lamp holder. I attached a link to print an extra one, please print it on 103% on X and Y for a good fit (depending on the used lamp holder).

Slats and mounting plates

Print with standard settings:

• 0.4 mm nozzle;
• 0.20 mm layer heigt;
• 15% infill;
• Bed temp: 65°C;
• Nozzle temp: 220°C;
• Printed with black PLA.

E27 Bulb

You can use any E27 bulb, make sure the bulb isn't too big to fit inside the lamp. It's recommended to use a dimmable or a weak bulb to prevent looking into the bright bulb. I used a bulb with only 250 lumen, so a dimmer wasn't needed. The bulb I used is the following:

Amazon: https://www.amazon.nl/CALEX-1101000900E27-bal-2700K-Clear/dp/B0CM3X5KJY/

Cord + lamp holder (diameter of the lamp holder must be 40 millimeter)

Amazon: https://www.amazon.com/AdiyZ-Pendant-Light-Cord-Chandelier/dp/B0C69JPY5S

AliExpress: https://www.aliexpress.com/item/1005008137529869.html (not sure if fitting diameter is 40 millimeter)
AliExpress: https://www.aliexpress.com/item/1005007349115212.html (not sure if fitting diameter is 40 millimeter)

Extra locking ring for lamp holder (print on 103% X and Y depending on the used lamp holder)

https://www.printables.com/model/150501-e27-lamp-shade-collar-ring

Please boost and like the model if you liked it, I would really appreciate that. I would love to see photo's of your prints as well!

Let me know if you are experiencing any problems!