Cigarette case for a pack of 30

The print has some strength issues, as the walls feel a quite flexible and I wouldn't feel safe putting it in a pocket. The supports for the lid are also quite difficult to remove to get a nice clean finish. The rounded transitions on the underside of the locking mechanism (the pins? idk what to call them), which makes those areas ugly and you can almost just pull it from each other 😅 The idea of mixing PETG and PLA is clever but I would love an alternative profile with PLA- or PETG-only version with an open hole, allowing users to insert a paperclip or a piece of filament as a pin. Fyi I accidentally picked 2 pla for the print so i dont know if the issue with the walls might be cause of that, but I can't imagine why the walls would use both materials

Simple yet effective. Sized to fit a standard 20-pack through simple scaling. Now, in the summer, when the pack needs to go in your pocket, this provides effective protection against creasing.

good design