Search models, users, collections, and posts
AirGradient ONE Multiboard Mount
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
53 min
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
5
9
6
2
13
7
Released
Description
Boost Me (for free)
If you enjoy this model consider giving me a boost!
AirGradient ONE Multiboard Mount.
If you have a decent 3D printer then no supports are needed. Printed with Multiboard's recommendation of 3 walls and 15% infill.
This model uses a load bering snap. It is a bit finicky since you need to snap it in at an upward angle, but once its in its strong.
Inspired by ex-nerd's model on printables for a similar HSW mount. Mine probably isn't as nice looking but I wanted to aim for not having to use supports to print it out.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)