Search models, users, collections, and posts
1" Shotgun M-LOK Mount for Magazine Tube
IP Report
Print Profile(1)
0.2mm layer, 6 walls 50% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
74
179
8
2
84
42
Released
Description
Brello Solutions has made a simple MLOK mounting fixture for standard 1" magazine tubes. This mount requires two (2) M3 x 10mm and bolts. It's printed with PLA and has been tested for multiple 100 shell range days without any issues, but can be printed with PETG without issue. This fits the Winchester SXP Defender which is pictured above.
Included in the file is a single shell mount. It's recommended to print a couple of these with different ‘X-Y compensation’ values to make sure you get a good snug fit on the shells. You can also heat gun or blowtorch on the mount to bend it into place to ensure a better fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (8)