Blink Doorbell Recessed Mount/Adapter

I have designed an adapter plate for the Ring Video Doorbell for flush-mounting or installation in an enclosure

The doorbell is flush-mounted with the plate and discreetly integrated The plate secures it against theft the plate must be properly fastened

For installation, the corresponding cutout must be prepared in the masonry or other building material

Battery insertion or permanent power supply must be prepared

Apart from the print, only two M4x12 or M4x16 screws and matching M4 hex nuts are required

A drilling template for the fastenings via printed threaded studs that are glued into the masonry is included in the print profile

Installation required parts

Procedure

Step 1 Print the model and drilling template

Step 2 Remove the back panel of the Blink camera with the unlock key

.     

Step 3 Insert two screws, in my case M4 socket head cap screws with a length of 12 or 16 mm, into the adapter plate, optionally securing them with a drop of superglue

Step 4 Snap the back panel onto the Blink camera

Step 5 Insert the camera into the printed adapter plate so that the screws protrude through the holes in the adapter plate at the rear

Step 6 Screw the M4 nuts onto the screws to connect the camera to the adapter plate

Step 7 Position the drilling template against the wall and drill 6 mm holes into the masonry

• Photos of the installation will follow

Step 8 Optional Connect the Blink camera to the power supply according to the instructions

Step 9 Commission and enjoy the fantastic features and the superb model I designed

Step 10 Rate and comment on the model and print profile and please leave a boost :-)

Please contact me if you have any questions