Search models, users, collections, and posts
Eiffel Tower in Parts
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.9 h
1 plate
Open in Bambu Studio
Boost
125
240
32
31
734
303
Released
Description
I tried to fix most of the errors in the original version so that the tower was OK. Three test prints came out fine for me, so I'm publishing them, because more heads, more knowledge :-).
I simplified the original model to three parts, because in larger printers there is no problem with that.
If there would be a problem in smaller ones, we will adjust ;-) .
The dimensions that suit me and that I publish here with the printing profile are the base 13x13cm and the total height 35cm .
Finally, everything is glued together with glue, although it holds even without it.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (32)