Search models, users, collections, and posts
LegoStar Wars UCS Slave 1 75060 Wall Mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 40% infill
Designer
3.8 h
1 plate
Open in Bambu Studio
Boost
27
103
10
0
69
55
Released
Description
A wall mount for the LEG 0 UCS Slave I 75060 | 75409
I changed some settings for a bit less Material at same strength.
Added some small supports in the print profile that are quite easily removeable directly after the print!
Printed on a P1S within 3h with PLA
- Remove print and check for any inconsistency
- Sand any bumpy edges on the mount square.
- Remove the engines
- Remove (or fold up) t-piece between engines.
- Fit ship side mount.
- Fit one or more technic pegs to hold the model in place
- Slide onto wall side mount you mounted on the wall before
- Profit!
Remix of a version found on Thingyverse
Boost Me (for free)
These models are usefull for you? The consider boosting me. It´s free for you and helps me! 👍😁 Thank you!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)