Search models, users, collections, and posts
Atari 2600+ Joystick and Rubber Boot Replacement
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
2 plates
Open in Bambu Studio
Boost
12
30
2
2
32
11
Released
Description
My dog chewed up my new Atari 2600+ joystick, so I went looking for STLs for replacement parts and was unable to find any for the new 2600+ joystick, the CX40+. I printed the joystick in PLA and found that using the Bambu PLA support material I was able to very easily remove the support without damaging the parts on the bottom that interface with the PCB.
The boot was printed in a generic TPU, with support. I didn't have any issues removing the support, but your mileage may vary since I just used whatever TPU I had laying around.
Installation is very straight forward, remove the 4 screws on the bottom of the joystick and from there everything is accessible and straight forward.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)