Motorola Advisor TPG2200 Belt Clip

German:

Belt Clip Mount for Motorola Advisor TPG2200

This practical holder with an integrated belt clip is specifically designed for the Motorola Advisor TPG2200 pager, often delivered without a case, as is common with the Federal Agency for Technical Relief (THW). This mount provides a secure and convenient way to carry the pager on your belt. The clip can be affixed in two ways, depending on user preference.

Printing Instructions:

• Material Selection: Employ a rigid filament, ideally incorporating CF (carbon fiber) or GF (glass fiber) for the necessary “snap” fit to securely retain the pager. (PLA is also suitable)
• Supports: No support structures required.

Bill of Materials (BOM):

• M3x4 screw (preferably with hex socket)
• M3 DIN 439 screw nut – smaller than standard M3 nuts (available on Amazon)
• Metal clip (available on Amazon) !!Vendor may have changed. Compatibility uncertain!!

Assembly Instructions:

1. Insert the nut into the case’s interior slot.
2. Slide the clip into one of the rear slits.
3. Thread the screw through the clip and tighten against the nut – avoid overtightening.

Inspiration and Adaptation:

This design, a remix of floergri’s Printables original, incorporates enhanced features and customizations particularly beneficial for use with the Federal Agency for Technical Relief (THW) or similar emergency response organizations.