2025 CFP CHAMPS

My first attempt at doing a Hueforge print that has a model attached to it. my print came out just as I thought it would I hope yours does as well

Project: 2025 champs.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x195.65mm in size
You may print at higher layer heights below the Min Depth of 2mm
The Max Depth is 5mm and the Actual Depth is 3.1mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA PolyLite Grey Transmission Distance: 1
    PLA PolyLite Red Transmission Distance: 1
    PLA polyLite White Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #28 (2.32mm) swap to Blue Gray
    At layer #29 (2.4mm) swap to Grey
    At layer #33 (2.72mm) swap to Red
    At layer #34 (2.8mm) swap to White for the rest.