Valentine's Love Heart Box, magnetic

Love Heart Secret Box with Magnetic Lead and a massive Rocket

(When I started to work on this model, I thought that I make a love heart box, with an arrow, then I ended up with this big rocket)

I made 2 versions of this model, one for the CA007 6x3mm round magnet set, and the other one for the CA004 6x2mm set.

The 3MF print profile is for the taller magnets.

• Easy to print and prints well without AMS / AMS-lite
• can be printed without support
• fits on A1 mini
• You do need the CA007 / CA004 round magnet set. 3 magnets for the bottom and another 3 for the lead.
  (check out these magnets from amazon: Walolo 6x3mm)
• the  parts of the rocket works with or without glue.

Printing instructions: 

The top and bottom of the heart has the magnets, hidden inside, so you need to add pause to the print, just before it does close the hole for the magnet.

1. The bottom of the heart box, print it upside down and add pause at layer 24. Can be printed without support, just to save some filament, but if you are looking for the extra quality, then apply support manually.
2. The 2nd plate, the top or lead of this box, and again pause your print at layer 23 and add the magnets, then resume the print. Apply 0.35mm  top surface layer for a smooth finish.
3.  The 3rd plate is an easy one, print it with 0.16mm layer height
4.  For the front of the Rocket, you need to add pause (if you don't have AMS) at layer 126, change the filament manually and return to the print. Or just print it in single colour.
5.  These are the small bits for the Rocket, standard settings, 0.16mm layer height.

Good luck and happy printing