Harry Potter Puzzle Box

This is a Makerworld version of The HammockGuy's puzzle box from Thingiverse!  https://www.thingiverse.com/thing:3269652

IMPORTANT!!!!

Both AMS and NON-AMS Plates are in this print profile.  I have labeled each plate with AMS or NO AMS as the prefix.  If you do not have an AMS the lid will have to be printed in all black so just update the mismatch.  The print profile for the lid is set up for ONE (1) AMS.  I have a pause halfway so you can swap your yellow for red and blue for green.  THIS IS CRUCIAL FOR A CORRECT PRINT.  

Please note there are two key trays.  One (1) for if you wish to use the 3D printed spring and another should you choose to not use it.  The one without the spring has finger grips and no space for the spring.  You will need to choose which one you want before assembly as you have to glue this print together with superglue.

If you have an AMS You only need to print the silver spring and key.  The other parts are for those who do not have AMS.  You just need to deselect them prior to printing.

After you have all the parts printed see the link below for a video containing the assembly instructions. Besides the printed parts you will need one piece of 1.75mm filament 5 inches long, a standard pen spring, and some super glue. The assembly is very easy just make sure you have all the parts in place before you apply the glue.

Demonstration video:
https://youtu.be/hrmvgV9LExE

Assembly video:
https://youtu.be/ze1X3e2B44o