Cthulhu Death May Die Insert through S4

Updates: 
2/9/2025 - Changed the Overlay Dashboard Left & Right by opening up 2mm to allow room for 5 full dashboard overlays to be printed

This is a board game insert for Cthluhu Death May Die

https://boardgamegeek.com/boardgame/253344/cthulhu-death-may-die

My goal with this design was to create a single box to organize all investigator models and player setup components in one box and a second box for all monsters not directly within a EO or Episode box. I also wanted to minimize the need to dig into the boxes so that content could easily be found. To do so, I used large boxes that do create box lift, but allows for content to come out vertically. 

NOTE: While I did some planning for S5 / S6 such as with player markers, this will need to be adjusted later with the new content. I expect to need to spill over some unknown monsters into another box, but investigators should be possible with a single box setup still. Also, I don't own the Unspeakable box or any of the promos. However, since the monsters are kept in scenario boxes the content doesn't change for the monsters and there's plenty of room as I've shown for the extra investigators. 

I have a video overview of what this content if you'd like to watch:

Things to note:
1) This takes 4.5 rolls of filament. It's a lot, but I didn't feel the two boxes were that heavy after everything. 
2) The way I've oriented everything in the 3mf file nothing needs supports. It's a lot of plates which is unavoidable due to the sizes. 
3) There are 10 total pieces to be glued together. The process I use makes this really simple. You can follow this video I made here
 

But the basic process is:
I use this activated adhesive: https://a.co/d/8laYAcL
I apply the glue to one side then put them together. There are connection points to make it easy to keep in place. I wipe off the excess. I spray the activator at the seams and just enough gets in that it's immediately connected and ready to use. 
4) I'm including the labels I used. You can use the photos to help find where the monsters go to line up with them. The investigators you may need to adjust if you have more of the content. 
 
The specific overlay for the player dashboards I printed is: 
https://cults3d.com/en/3d-model/game/cthulhu-death-may-die-player-dashboard