1984-1986 Honda Spree Glovebox

If you're the owner of a Honda Spree i'm sure you're quite familiar with the lack of storage space. Honda themselves knew this was an issue so as an optional extra you could purchase a glove box. These glove boxes have been quite hard to come by. I was able to obtain one and decided I should share its utility with my fellow Spree riders. I have copied my box to the best of my abilities (1 week of fusion 360 experience.). This print BARELY fits on the print bed of my P1s and had to be orientated at an angle upside down.  This can cause some ugly layer lines that can be sanded out. Fitment is decent, once again i'm not really a master at fusion 360 yet. I have copied my factory mounting hardware and thickened them up to be printed. Stock clips are steel (as shown in my pictures). I would highly recommend this be printed in something outdoor rated like PETG. My test print is PLA and seemed to deal with the stress of being bolted to the scooter. 

NOTE: Two holes must be drilled into your front leg guard to mount the box to the panel. One additional screw must be screwed into the leg guard as well. This hole is more obvious as a casting mark is placed there. 

Feel free to customize this model. I simply ask that my logo in the bottom right stay attached to the model.