MTW Dust Cover Grip

So after several games of having to remove my gloves to access the hop-up to make small adjustments I decided to create this Dust Cover Grip for my Wolverine Gen 3 Billet Series, MTW 9, and MTW 308. Its a simple snap-in that holds in place fairly well without the need of any glue or modifications. There are two versions, a Normal and 308 version. The 308 dust cover is about 1mm taller than the normal MTW dust covers.

To attach Just slide the top part onto the top of the dust cover then push the bottom tab in until you hear a click. To remove u just open the dust cover and push down on the bottom tab. Simple as that. I used PLA but you can use whatever filament you have.

Print settings I used

-Seam Position : Back
-Walls : 4
-Wall Generator : Arachne (Helps with thin parts like this)
*You may need a brim if you aren't using a CryoGrip or similar plate.