G29/G920 Clamp Extender for Steering Wheel - Free 3D Print Model

Search models, users, collections, and posts

Spleenster

Hobby & DIY>Other Hobby & DIY

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 40-60% infil

Designer

1.5 h

1 plate

4.6(5)

Open in Bambu Studio

Boost

101

124

Released

Description

Extends the length of the clamp itself without making it taller, needed it for my desk that has a metal bar right under it for support that stops the normal clamp from having enough room to grab on when my desk is in L desk mode.

You have to open your steering wheel to install this, there are many videos online to help with it, not too hard, just a lot of screws.

You have to install it by putting the teeth part through the top. Since it's longer, it doesn't fit the normal way. Requires a little bit of force, but nothing crazy and it pops in.

If anybody does print this for use, would appreciate a picture for the post of it before it's installed, i forgot :)

Print with 40-60% infil since it's going to have a lot of pressure on it

Thank you @chriscarlton73 for the before-installation picture :)

Comment & Rating (17)

@chriscarlton73

Boosted

Looks good so far haven't put them in yet will let you know

The designer has replied

@Spleenster

Thanks for the picture! I found it easiest to install backwards (Putting the side with the teeth in through the top of the open steering wheel area and applying a bit of pressure from the top and it just popped in!).

@chriscarlton73

Boosted

Replying to @Spleenster :

Works great don't mind the mess please thanks!!

@Spleenster

Replying to @chriscarlton73 :

Glad it worked for you, thank you for sharing pictures!!

@solracs

Boosted

Print Profile

0.2mm layer, 2 walls, 40-60% infil

Really good, it feels super durable and the grip is really good. However I think it is a little bit too long, to the point that I cannot access two (one per side) screws with my screwdriver.

@solracs

Boosted

Really good, it feels super durable and the grip is really good. However I think it is a little bit too long, to the point that I cannot access two (one per side) screws with my screwdriver. 4/5 stars.

@tzfaen

I haven’t been able to position the part correctly, are there any tips you could give me, perhaps even a video showing how to install it? I’ve tried for a long time and am at my wit’s end 😔

Show original

@Fil0Fox3s

I advise you, as the creator says, to insert the tooth part from above, position the fillet part slightly to the left so it goes a little further, then push or pull to secure it within the tooth part with a little force and patience

Show original