Holder for Square Contactless Card Reader - Free 3D Print Model

Search models, users, collections, and posts

Z3Designs

Tools>Organizers

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 5 walls, 15% infill

Designer

3.2 h

1 plate

4.9(23)

Open in Bambu Studio

Boost

149

421

406

264

Released

Description

Wanted a holder for my Square Contactless Card Reader. This is easy to print, the reader sits in it nicely, and it even allows for charging while docked. Has a place for the sticker that comes with your reader!

Boost Me (for free)

Like my model? Feel free to boost it!

Comment & Rating (41)

@xnetgeek

Boosted

wish the sticker was more tacky, but that's on square.

The designer has replied

@Z3Designs

agree! a few dabs of super glue in the corners helped me.

@xnetgeek

Boosted

Replying to @Z3Designs :

didn't melt the sticker? I may have to attempt that.. so far I heated it up with my torch.. super fast past.. made the glue a little more sticky.. so far it's holding.. but I imagine when I get it in the sun, it will wripple again.

@Z3Designs

Replying to @xnetgeek :

no I use ca glue, same stuff to glue pla together. sticker is still holding good.

@rgbivens

Boosted

Print Profile

0.2mm layer, 5 walls, 15% infill

This stand printed great! I added a small 3mm by 50mm piece of double sided sticky foam tape to the left side of the reader which perfectly wedges the reader into the opening. The space for the sticker could be ever so slightly taller. The width for the sticker was spot on though. I've added some velcro command strips to the bottom of the holder to affix it to a table so it doesn't slide around.