Prism for Christmas Tree

Prism for X-Mas tree.

It reflect the tree lights from any direction, even behind being transparent,

Very Light, only 4g.
it is quite fast to print: less than 1 hour.

No support needed.

The bottom (bottom when printing, top when on the tree) has a gap for a small cord to hang it on the X-Mas tree.

IMPORTANT:
For the best outcome, I used these settings:

• Wall Line: 1 (to make it as transparent as possible, using the PETG it comes out quite strong, I did not have transparent PLA)
• Infill: 0 (again to make it as transparent as possible)
• Support: NO

P.S.
I thank my wife for being my inspiring muse, as always

Print Settings                                           

Supports:                      

No

Filament:  PETG transparent                    
Wall Line: 1
Infill: 0
Support: NO

Very Light, 4g, but in PETG it come out strong.
With only 1 wall line it come out trasparent and looks almost like glass.

I suggest not to use vase mode ("Spiralize Outer Contour" for Cura) as the base has a gap for a small cord to hang it on the tree.

Post-Printing

Just insert a small cord to hang it on the tree.

How I Designed This

Designed with Autodesk Fusion 360

Thanks to