Flying Copter - TOY

a very fun model that will keep you and your children busy for a long time. I myself had a hard time getting away from it.

Very simple print. you take it out of the printer and you can fly immediately. no extra needs.

IMPORTANT 3 steps!

1. after printing, it is necessary to thoroughly clean the area of gear with a knife or something else from the remains of the material after printing

2. After removing it from the Bed, it may happen that the propeller will not be smooth and will get stuck as in the video:

3. The solution is shown in the next video. it is necessary to make the gear mechanism smooth by pulling forward and backward for a few moments as in the video:

I remembered that I had a similar toy when I was little and at that moment I thought I had to have it again.
functionality is great.
you can fly at home, but it's much better outside. I recommend you try it :)

flight demonstrations:

Waring: risk of injury from the propeller. not recommended for children under 3 years old.