Pin for Xiami Band 8

German:

This is a replacement pin for the Xiaomi Band 8.

It was 3D-printed using PLA filament. However, careful selection of the PLA is crucial, as not all filaments exhibit sufficient layer adhesion, potentially leading to breakage where the pin meets the axis.

For my pin, I employed Ultrafuse Ice Blue filament, and so far, it remains intact. Nevertheless, I had to experiment with several filaments, as the risk of fracture is contingent upon the filament's properties.

This marks my inaugural self-designed model. It's quite possible that superior, comparable designs already exist.

English:

This is a replacement pin for the Xiaomi Band 8.

It was printed in PLA. But you have to be careful which PLA you use. Not all of them have a sufficiently good layer adhesion and can therefore break easily at the transition from the plate to the axis.

I used an Ultrafuse Ice Blue filament for my pin and the pin has not yet broken. However, I did have to print and test a few filaments as there is a risk of breakage depending on the properties.

This is my first self-designed model. It may well be that other, similar and better models already exist.

Translated with DeepL.com (free version)