Frylock Aqua Teen Magnet(8x3mm magnets)

Pictured Example printed on a BambuLab X1C (Textured PEI)

Print Settings:
Initial Layer Line Width: 0.4mm
Wall Generator: Arachne
Wall Loops: 1
Bottom Surface Pattern: Hilbert Curve
Infill: 15% (Gyroid)
Initial Layer Speed: 30mm/s

Coloring: Prints have at least two main objects that I usually set as white (base) and black (outline). Additional coloring was added manually with the paint bucket and other tools. Note: For this print, the fries have some open areas, so you may have to paint brush to close the open areas before you use the paint bucket fill the inner area.

8x3mm Magnets to be glued in (magnet strip can be used instead)

Hope you enjoy!