Red Dwarf Magnet (8x3mm magnets)

Pictured Example printed on a BambuLab X1C (Textured PEI)

Print Settings:
Initial Layer Line Width: 0.4mm
Wall Generator: Arachne
Wall Loops: 1
Bottom Surface Pattern: Hilbert Curve
Infill: 15% (Gyroid)
Initial Layer Speed: 30mm/s

Coloring: Prints have at least two main objects that I usually set as white (base) and black (outline). For this print, both base objects were set to black, while the outline objects were set to red and green, respectively.

8x3mm Magnets to be glued in (magnet strip can be used instead)

Hope you enjoy!