Bottle Cap with First Aid Pictogram 28mm 2L bottle

This model is just the Bottle cap for the common 2L soda bottles with a First Aid pictogram embossed in 2 colors. 

If you need a container, check my other models, got tons of them -> https://makerworld.com/en/collections/4546564

This cap is compatile the typical PCO 28mm Type 1881 threads found on several 2L and plastic bottles. 

This design includes the internal rib in the cap to help the seal, but this cap is not most likely not tight.  My own testing shows that water does not leak out, but your mileage may vary. Shown in Bambu Lab PLA Basic, PETG has move flex so I prefer my PETG caps.

Less than 6g ! This is an ideal print to use the remaining of almost empty spools (see tips below “to print by objects”).

Feedback / comments : This little cap has so many uses, I can't list them all ! I'd like your feedback on my free models and what you use them for. Thanks for sharing your positive experiences and other ideas are welcome.  

Dimensions :  

⌀32mm diameter  

Printing: 2 colors, No supports needed, print the cap upside down with the threads up.  My print profile is design to be a pretty continuous nozzle print movement with smooth moves.  This is not a tall part, so a brim shall not be required.  If you encounter 1st layer adhesion add a brim.

Print by objects : No sure your spool was enough filament left ? No problem, if you print "by objects", the Bambu labs machine will print each model one my one.  It needs more space between the models on the bed space, but the machine will print the objects one after the other.   Wiki on Print-by-objects : https://wiki.bambulab.com/en/software/bambu-studio/sequent-print