Search models, users, collections, and posts
Door Stopper
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
Increased the height added 2cm
35 min
1 plate
higher and short - 0.2mm layer, 2 walls, 15% infill
28 min
1 plate
Open in Bambu Studio
Boost
300
932
64
12
1.1 k
800
Released
Description
Content has been automatically translated.
A quick (19min) print. This doorstop doesn't obstruct like other models.
Its lip smoothly slides into the recess. To open the door, simply pull it in the opposite direction.
Add a bit of tape beneath the stopper to prevent movement.
Boost Me (for free)
Let me see your prints and feel free to share any problems with me
Boost Me (for free)
If you like my models, I would appreciate your support
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (64)