Keychron K15 Pro/Max palm rest

It's very good! It shows a ready-made level of integration. x2d tpu 90a 0.16

Has anyone tried printing this on either the A1 or P2S? I have tried on both printers three times each and the print fails for Body1_B at the same place each time. Body1_A printed fine.

Looks amazing!

Would this work with A1 mini

Awesome print! Used 95A TPU @ 0.20mm layer height and 25% infill, came out great. Very comfy, just a tiny bit of give in the cushion adds a lot.

It fits perfectly on the k15. Care must be taken when printing and attaching the two parts. The model is flawless, but slight misalignment can occur if the attachment isn't perfect. It was my first print, and I'm extremely pleased with the result. Note that the top and bottom print in reverse

Perfect for the K15