Drink Packet Organizer
Print Profile(1)
Bill of Materials
Description
Organize your drink packets all in one place! Using the optional base, the entire organizer rotates for ease of use. This optional (but recommended) base requires the use of a standard 608 bearing.
Print Settings
The main organizer requires no special settings. The base should be printed with a high infill percentage. The extra weight will help keep the base steady while the organizer is spinning. I also recommend ironing the top surfaces of the base that will make contact with top section.
Assembly Instructions
Press a 608 bearing into the hole on the bottom of the organizer. This should be a tight fit. Set the organizer on the base so that everything aligns the same as below:
Note: The connection between the base and the bearing is not a tight fit. This allows you to remove the base at anytime or swap it out for a different color.
The following filaments were used in the pictures above:
- Bambu Lab Galaxy Nebulae PLA
Membership
Are you looking for a Commercial License for all JamesThePrinter models?
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (270)