XLR end cap - outer thread plugs 17.5x1, 5.9 cable

End cap for XLR plugs with an outer thread, like the “old” Neutrik NC3FX.

Fits male and female plugs.

Max cable diameter 5.9mm - but it is a tight fit!

Does not replace the internal cable clamp.

I printed the 5.9mm version in PLA and the 6.5mm in PETG, both worked.

There are no supports slices with tree support. 

I found that there is a small filament string (⅓ of an inch or so) on the thread that will need removing - which worked quite easily on all test prints.

The 6.5mm version is uploaded as a separate model.