LED Cube 8x8 WS2812 WLED

Here is my first complex Upload.

I designed it from scratch, with some inspiration from other 8x8 cubes. 

With six of the 8x8 WS2812 Matrix with flexible PCB, I needed to design it a little bit differently.

You Need:

• 50x 3x1mm magnets
• 6x WLED Matrix flexible 8x8 (available on different platforms)
• 1x ESP32 with WLED installed (I use an Atom M5)
• 1x Power Supply 5V (I use 2.5A)

Prepare:

2x Magnet press tool in 2 different colors and a glued on magnet with different polarity on top

Steps:

1. print all Parts
2. press the magnets in the Parts

3. clip the three bottom Parts and the three top parts to half a cube together 

   (maybe you need some needle nose pliers)

4. insert the led panel (on the bottom side, you need to cut an edge to fit)
5. insert the led clamps behind the panels (the red parts in the picture)
6. insert the cable through the stand and into the cube
7. put all cables together 
8. Have fun with WLED :-)

Hope you enjoy it!

25.01.2025:

changed from 2.5x1mm to 3x1mm magnets